DanyD7613 DanyD7613

16-01-2024
Engineering

contestada

What is the feed rate for a turning operation on a 4.0 in. shaft at a cutting speed of 500 ft/min and a feed of 0.014 in/rev?
a. 1.4 in/min
b. 3.5 in/min
c. 7.1 in/min
d. 35.7 in/min

Respuesta :

Otras preguntas

Show all work to write the equations of the lines, representing the following conditions, in the form y = mx + b, where m is the slope and b is the y-intercept:

MN and KL are parallel. If JM=8, MK=40, and LN=30, what is NJ?

What is an alphabetical list of sources referenced in a paper?

Use the change of base formula to evaluate log4 20.

_____ is(are) released when blood glucose levels drop.

Devaughn is 13 years older than Sydney. The sum of their ages is 77 . What is Sydney's age?

Calculate the simple interest you would receive in one year on a savings account that earns 5% annual interest. your beginning balance is $255.19.

I'm having trouble finding the answer to this question

PLEASE HELP! Write the quadratic function in the form f (x) = a (x-h)^2+k . Then, give the vertex of its graph. f (x) = 2x^2 - 12x +16 Writing in the form

Which tectonic plate boundary caused the structure that is circled in the image? oceanic-continental convergent boundary oceanic-oceanic convergent boundar